disable mac address learning within a vlan

DISABLE MAC ADDRESS LEARNING WITHIN A VLAN MANUAL
DISABLE MAC ADDRESS LEARNING WITHIN A VLAN SOFTWARE

Untagged ports interface type and identifier. Untagged - Untagged ports interface type and identifier. Port-channel a,b,c-d - Port-channel identifier. Member ports interface type and identifier. Ports - Member ports interface type and identifier.Īdd - Add ports to existing VLAN port membership list. The no form of the command configures the default priority for the tunneled STP BPDUs. Show vlan device info - Displays the VLAN related global status variablesĬonfigures the priority for the tunneled STP BPDUs.

To configure the bridge mode of the switch:.

If multiple bridge modes are required, run multiple instances of the bridge.

Only one bridge mode can be set at a time.

SEFOS(config)# bridge-mode provider-backbone-icomp Provider-backbone-bcomp - Provider backbone bridge B component mode.īased on the bridge mode value in issnvram.txt. Provider-backbone-icomp - Provider backbone bridge I component mode.

Provider-edge - Provider edge bridge mode. Provider-core - Provider core bridge mode. No mac-address-table static unicast aa:aa:aa:aa:aa:aa vlan 1-4094 [ show interfaces - Displays the interface status and configurationĮnables or disables GVRP on a global basis.interface - Enters into the interface mode.For port channel range, the specified range must be configured using the interface command.That is, the command interface range vlan 1 - 4 is valid, whereas the command interface range vlan 1- 4 is not valid. For specifying the interface VLAN range, space should be provided before and after the dash.SEFOS(config)# interface range extreme-ethernet 0/1-23 vlan 1 - 128 SEFOS(config)# interface range vlan 1 - 4 extreme-ethernet 0/1 SEFOS(config)# interface range vlan 1 - 4 extreme-ethernet 0/1-3 SEFOS(config)# interface range vlan 1 extreme-ethernet 0/1 SEFOS(config)# interface range extreme-ethernet 0/1-23 vlan 1 - 2 Slot/port-port - Member ports identifier. The no form of the command deletes a VLAN from the switch.

show mac-address-table dynamic multicastĬonfigures a VLAN in the switch and is also used to enter into the Configuration VLAN mode.

show mac-address-table static multicast.

show dot1d mac-address-table static multicast.

show dot1d mac-address-table static unicast.

The list of CLI commands for the configuration of VLAN is as follows:

The prompt for the Global Configuration mode is:.

Multiple Instance is not supported in this release.

The list of CLI commands for the configuration of VLAN are common to both single instance and multiple instance except for a difference in the prompt that appears for the switch with multiple instance support.

Optimized broadcast and multicast activity.

VLAN provides the following benefits for switched LANs:

DISABLE MAC ADDRESS LEARNING WITHIN A VLAN SOFTWARE

VLANs are configured through software rather than hardware, which makes them extremely flexible. That is, a network of computers that behave as if they are connected to the same wire even though they may actually be physically located on different segments of a LAN. VLANs can be viewed as a group of devices on different physical LAN segments which can communicate with each other as if they were all on the same physical LAN segment.

DISABLE MAC ADDRESS LEARNING WITHIN A VLAN MANUAL

Sun Ethernet Fabric Operating System CLI Base Reference Manual

Disable mac address learning within a vlan